Amico NuLook FlexWall, Руководство по установке

Страница: 9 / 12

www.amico.com 9
Installation
8. Bring the pre-installed conduits with wire whips (loft) to the existing electrical device boxes by passing them through
the openings between the frames.
IMPORTANT:
Make sure the labels on the conduit matches the labels on the Engine.
9. Pull wires through the Engine conduits to the termination box and install cover plates over the box.
10. Attach all removed items:
• Panels (must clip in properly where applicable)
• Devices and cover plates
• Reinstall the rails (if applicable)
IMPORTANT: Do not overtighten the medgas and electrical cover plates.
IMPORTANT:
(If Applicable) Install the Vertical Rails onto Frames with screws. Reinsert the Vinyl Strip into the
Rail to cover the Screws. (Must use the same hardware removed from the rails in Step 3 of
Panel Frame
Installation
).
Figure 9