Amica 111.3YW, Инструкция по эксплуатации

Страница: 12 / 36

12
ELECTRONIC PROGRAMMER (oven type 11*TaY*)
A - display field
B - work function symbols
- work time
- turn-off time
- timer
- current time
- signal lamp
1 - programmer work function selection
button
2 - button „-”
3 - button „+”
CURRENT TIME SET-UP
After plugging in or reconnecting to a power
source after current decay, the dis play shows
12.00 , and the lamp at flashes ,
• set up the current time using buttons
2 and 3 .
About 5 sec. after the time set-up has been
finished, new data will be memo rized and the
lamp at will go out.
The time correction can be done later, press-
ing button 1 until the lamp at starts to flash.
Then you can correct the current time.
Notice!
If the current time is not set up, it is im possible
for the oven to work.
A
2
B
3
B
1
TIMER
You can activate the timer at any time, regard-
less the activity state of other pro grammer
functions. The measured time ranges from 1
minute to 23 hours 59 minutes. With the aim
of setting up the timer:
• press button 1 until the lamp at
starts to flash, and the dis play
shows “ 0.00 ”,
• set up the timer using buttons 3 and
2 ,
The set-up time is pre sented on
the display, and the lamp at is
turned on.
After the set-up time has elapsed, a sound
signal turns on and the lamp at starts to
flash again,
• press buttons 1 , 2 or 3 to turn the
signal off; the lamp will go out, and
the display will in di cate the current
time.
Notice!
If the sound signal is not turned off manu-
ally, it will turn off au to matically after about
2 minutes.
OPERATION