amiad SAF-6000, Инструкции по установке, эксплуатации и обслуживанию

Страница: 16 / 28

SAF 6000 910101-000107 07.2019 Page 16 of 28
Dismantling and Assembling the Filter Components
Prior to opening the filter perform a flush cycle by pressing the "TEST" push button.
The Fine screen
Dismantling:
1. Close the filter inlet and outlet valves and release the pressure.
2. Press the "TEST" push button and disconnect the power when the scanner is in the middle of its track (When the limit switch disc is
half-way between the two limit switches).
3. Release the lid bolts (17) from their nuts.
4. Locate the centering sleeves, remove them from their holes and remove the lid (16).
5. Remove the seal (9) from the screen (10) and pull it out of the filter housing.
6. Remove the second seal from the screen.
Assembly:
1. Put the screen seal (9) on one end of the screen (10).
2. Insert the screen (10) into the filter housing (1). Make sure the screen is correctly positioned, all the way in.
3. Put the second seal (9) on the other end of the screen.
4. Assemble the lid on the filter housing. Make sure the screen and seal are correctly positioned in the lid seating.
5. Insert the centering sleeves into two opposite holes in the lid flange.
6. Insert bolts (17) with the discs on the lid side.
7. Place the discs and the nuts on bolts (8) on the housing side. Do not tighten them yet.
8. Tighten the bolts (17) in a controlled and balanced method.
9. Open the filter inlet and outlet valves and operate the control board.
10. Check proper operation of the filter.