COPYRIGHT © 2009 AMI ENTERTAINMENT NETWORK, INC.
PM0426-26 Rev A MEGATOUCH ION EVO OWNER’S MANUAL
PROFILE OF COIN MECH BRACKET
Coin Mech Position- eVos with Coin Mechs Only
If you remove the coin mech for any reason, you must replace it in the correct
notches in the coin mech bracket so that the mech remains vertical. If your
game is sitting on a table or bar top, make sure the tabs on the coin mech are in
the notches labeled “BAR MOUNT” below. If your eVo is mounted on a wall (with
or without the use of the swivel bracket), make sure the tabs on the coin mech
are in the notches labeled “WALL MOUNT” below.
BAR
MOUNT
WALL
MOUNT
Connecting a Printer (German Games Only)
To connect a printer to the game as needed:
1.
Locate the printer port on the back of the game (see Figure 33).
2.
When the game enters idle mode, connect the printer to the printer port on the game.
NOTE: Some printers may cause the game to reboot. Once the game has rebooted
and entered idle mode, the printer will begin printing. Do not disconnect the
printer until it is finished printing.
Um einen Drucker an eine Maschine anzuschliessen:
1.
Den Druckeranschluss hinten am Gerät feststellen (Siehe Fig. 33).
2.
Wenn das Geraet in den Leerlauf uebergeht, den Drucker am Druckeranschluss des
Geraets anschliessen.
BEMERKUNG: Bei bestimmten Druckern rebootet das Geraet. Nachdem das
Geraet dann in den Leerlauf uebergeht, beginnt der Druckvorgang. Den Drucker
bitte nicht abschalten bevor der Druckvorgang beendet ist.
4
