AMF-BRUNS Alu Ramp, Руководство по эксплуатации

Страница: 12 / 56

Safety
Page 12 of 56 Alu Ramp
1.6 Safety Devices
Electrically operated belts
Electrically operated belts, with which the wheelchair is se-
cured when driving, are attached to the front area of the
vehicle's floor. These electrically operated belts can only be
pulled out when the Alu Ramp has been fully deployed and
the indicator lamp in the rocker switch is lit (refer to Section
2.4, page 20). The electrically operated belts retract auto-
matically when the rocker switch is in either position. Before
the wheelchair can be pushed or driven up the Alu Ramp,
the electrically operated belts must be attached to the
wheelchair and the rocker switch must be operated such
that the indicator lamp goes out. This will prevent the wheel-
chair from rolling back out of control.
1.7 Safety and Accident Prevention
Regulations
Adhere to the following notes in order to prevent personal
injuries and material damage. For commercial use, also ad-
here also to the relevant safety and accident prevention
regulations laid down by the trade associations.
The Alu Ramp must only be operated if all safety and pro-
tective devices are correctly fitted (see Section 1.6). Such
devices must only be removed in order to enable mainte-
nance and repair work to be carried out. All safety and
protective devices must be replaced immediately after
such work has been completed. If they are not replaced
correctly, there is a high risk of injury.
The Alu Ramp must only be used for the purpose for
which it is intended, otherwise dangerous situations, with
resultant injuries, may occur (Proper Use: see Section 1.1,
page 9).
The owner is responsible for ensuring that proper use is
adhered to, in particular that the Alu Ramp is only oper-
ated by authorised persons.