© 2021 AMETEK Power Quality Solutions | Technical Support 800-645-9721 | surgex.com
10
User Manual
5.4.1 Device Setup
The Device Setup page allows for the specification of basic device parameters.
5.4.1.1 Device Configuration
The Device Configuration tab allows for the specification of visual feedback, and
device initialization.
Device Configuration
Item
Description
Device Name
Specifies the name label to be associated with this Squid.
Nominal Voltage
Specifies the expected voltage on the input receptacle. This selection does NOT change any
settings for over/under voltage shutoff. This is only for visual coloring on gauges.
Nominal Frequency
Specifies the expected frequency on the input receptacle. This selection does NOT change any
settings for triggers. This is only for visual coloring on gauges.
Power Up Delay
Time
Specifies the amount of time in seconds by which to stagger the manual turning on of multiple
outlets when applying the initial state.
On Power Up
Specify whether to set outlets to Initial States or run a predefined Sequence when Squid powers
up, or the Hard Reset button is pushed.
On Shutdown Clear
Specify whether to set outlets to Initial States or run a predefined Sequence when a Shutdown
State clears.
Temperature Display
Specifies whether to display temperature in degrees Fahrenheit or Celsius.
Auto Logout
Specifies the web security timeout in minutes.
Auto Ping Frequency
Specifies how frequent the Squid will send pings to an IP Address or Hostname in an autoping
trigger.
Auto Ping Timeout
Specifies the amount of time the Squid will wait for a ping response before calling the attempt a
failure.
