![background image](http://html1.mh-extra.com/html/ametek/sorensen-sg-series/sorensen-sg-series_programming-manual_2931312025.webp)
SG Series Programming
IEEE/RS232 Configuration and Remote Programming
M550129-03 Rev L
3-7
Table 3-2. Remote Power-on Conditions
Condition
Default
Voltage
0 Volts (initial from factory power-on voltage); otherwise,
last value saved by SCPI command.
See CAL:INIT:VOLT
Current
0 Amps (initial from factory power-on current); otherwise,
last value saved by SCPI command.
See CAL:INIT:CURR
Soft Voltage Limit
Model maximum voltage
*
Soft Current Limit
Model maximum current
*
OVP Trip Voltage
Model maximum v10% (initial from factory power-
on OVP); otherwise, last value saved by SCPI command.
See CAL:INIT:VOLT:PROT
Delay
0.5 seconds
Foldback Protection
OFF (non-configurable)
Output
ON
**
See CAL:MOD:POWERON
Hold
OFF
Unmask
NONE
Service Request
Capability
OFF
* User-programmable temporary limit (reverts to power-on defaults after power
cycle or Reset command is issued).
** User-selectable.
Содержание Sorensen SG Series
