AMETEK CTS
NSG 4070
Quick Start and Safety Guide
8 / 20
1.15 Warranty Terms
AMETEK CTS provides this written warranty covering the product stated above, and if the buyer discovers and
notifies AMETEK CTS in writing of any defect in material or workmanship within the applicable warranty period
stated above, then AMETEK CTS may, at its option: repair or replace the product; or issue a credit note for the
defective product; or provide the buyer with replacement parts for the product.
The buyer will, at its expense, return the defective product or parts thereof to AMETEK CTS in accordance with
the return procedure specified below. AMETEK CTS will, at its expense, deliver the repaired or replaced product
or parts to the buyer. Any warranty of AMETEK CTS will not apply if the buyer is in default under the purchase
order agreement or where the product or any part thereof:
•
is damaged by misuse, accident, negligence or failure to maintain the same as specified or required by
AMETEK CTS;
•
is damaged by modifications, alterations or attachments thereto which are not authorized by AMETEK CTS;
•
is installed or operated contrary to the instructions of AMETEK CTS;
•
is opened, modified or disassembled in any way without AMETEK CTS’s consent; or
•
is used in combination with items, articles or materials not authorized by AMETEK CTS.
The buyer may not assert any claim that the products are not in conformity with any warranty until the buyer has
made all payments to AMETEK CTS provided for in the purchase order agreement.
1.16 Prohibition of unauthorized conversions and modifications
The user is not entitled to the device to perform its own modifications and adaptations. Modifying parts on the
generator by unauthorized persons will void the warranty of the device and the correct functioning cannot be
guaranteed.
1.17 Specific accessories required for safety reason
Only use accessories approved by AMETEK CTS for these generators and intended as accessories for these
devices. Measuring instruments for the measurement of instrument parameters shall be designed for the maxi-
mum voltage and current from the generator. Otherwise safety cannot be guaranteed.
1.18 Procedure in case of hazard
If a hazard could exist due to an unintended condition of the device, the following procedure is recommended:
Disconnect the device- and EUT power supplies from the power supply and ensure that the device is always
earthed via the supply lines or a different ground connection. Wait at least 15 minutes and ground all outputs via
a 10 kΩ, 15 W resistor. Call an AMETEK service center.
