Ametek mocon Dansensor LeakPointer H2O, Руководство пользователя

Страница: 26 / 36

24 User Guide EN Dansensor
®
LeakPointer H
2
O
P/N 390225-C
11/2021
Adjustments
Lid adjustment
If the lid does not seal properly and evenly against the tub sealing, this can be adjusted:
NOTE! This requires that the sealing is correctly mounted on the tub - see
"Replacement of parts" on page 26 .
1. Loosen the 4 screws

(2 on each side) connecting the lid

to the console

.
2. Close the lid

and while slightly pressing it downwards, start the vacuum ejector and
adjust vacuum to approx. 100 mbar.
3. When you feel the lid being sucked close to the tub, verify that the lid seals evenly against
the tub sealing, then tighten the 4 screws

again.
4. Release the vacuum then start test again to check that lid seals properly now.