INSTALLATION INSTRUCTIONS
Amerlux
®
LLC | 178 Bauer Drive, Oakland, NJ 07436 | p: 973-882-5010 f: 973-882-2605 | www.amerlux.com
689-0512
pg 1 of 3
GRUV 1.5”
LED, Gypsum Board
WARNING:
WARNING: RISK OF FIRE AND ELECTRICAL SHOCK. FIXTURE MUST BE INSTALLED BY A QUALIFIED ELECTRICIAN ONLY.
FIXTURE IS INTENDED FOR INSTALLATION IN ACCORDANCE WITH THE NATIONAL ELECTRICAL CODE, LOCAL AND
FEDERAL SPECIFICATIONS. DISCONNECT POWER AT ELECTRICAL PANEL BEFORE SERVICING.
RETAIN THESE INSTRUCTIONS FOR MAINTENANCE REFERENCE.
RETAIN THESE INSTRUCTIONS FOR MAINTENANCE REFERENCE.
6”
X
X
12”
X
Suspension Points
Example of a Continuous Row
Individual Installation - (Individual fi xture shipped as shown)
1. Hang the Fixture via wire and/or
threaded rods. (Optional)
Blocking as shown by others.
2. Once the fi xture is secure, feed power
source through the knock-out. Splice to
harness according to code.
3. Install ceiling (by others).*
4. Spackle in fi xture.
5. Snap in Lens.
Hanging the fi xture via threaded rods.
Hanging the fi xture via threaded rods.
(Using Yoke)
(Using Yoke)
1. Insert 1/4-20 bolt and secure with nut. (supplied by others)
2. Secure to structure via coupling. (supplied by others)
3. Remove 7/8” KO in access cover at power feed location.
MINIMUM CEILING OPENING MUST BE HELD
MINIMUM CEILING OPENING MUST BE HELD
BY INSTALLER FOR THE FULL LENGTH OF THE RUN
BY INSTALLER FOR THE FULL LENGTH OF THE RUN
DO NOT REMOVE SHIPPING SPACE UNTIL CEILING IS FINISHED.
DO NOT REMOVE SHIPPING SPACE UNTIL CEILING IS FINISHED.
5/8”
2-1/2”
3-1/4”
Snap-in lens
* Fixture MUST be mounted before ceiling is installed.
* Fixture MUST be mounted before ceiling is installed.
3-
1/
2
”
Height @ supspension point
Mounting rods &
hardware by others
Support method
by others
3-
1/
4
”
Fixtur
e height
Ceiling contractor
to spackle, feather
& sand at ceiling
interface.
Blocking
support method
(supplied by others)
6”
6”
6”
Suspension
brackets supplied
by Amerlux
Purple
DIM (+)
Gray
DIM (-)
Green
White
Black
ACCESS PLATE DETAIL
WIRING CONNECTION
0-10V DIM shown. For Non-DIM applications
cap Purple (+) and Gray (-). Wire nuts supplied
by others.