© American Time
8
Wireless Digital Clocks Owner's Manual
D
e
scr
ip
ti
o
n
In
st
al
la
ti
on
O
p
e
rat
io
n
Co
d
e
B
lue
M
ai
n
te
n
a
n
ce
A
pp
e
n
d
ix
S
pe
c
if
ic
at
io
n
s
© American Time
In
st
al
la
ti
on
Wireless Digital Clocks Owner's Manual
Digital Clock Operation
Powering Up
Apply power to the digital clock. The firmware version number will appear for a few seconds, followed by all digits
illuminated. It will then scroll a digit pattern while it looks for the correct time from the SiteSync IQ system controller.
Once the receiver inside the clock gets a signal, the clock will begin keeping time. At first startup, the clock may display
a time such as 1:00:00 until it receives the first time update from the SiteSync IQ system controller. This should only
take a few seconds, after which the correct time from the SiteSync IQ system controller should appear.
Setting Time
Setting of the time is not needed for the digital clock or timer control station. The time information is automatically
updated by the SiteSync IQ system controller. The 12- or 24-hour mode option can be configured by the display
settings of the system controller, or by the push buttons on top of the clock (see
Setting 12 or 24 Hr Mode
on pg 11).
The ATSTCS timer control station will allow the user to set a 12- or 24-hour mode and time when the
SET/RUN
switch
is in the
SET
position. However, the time and the 12- or 24-hour format will be overridden by the SiteSync IQ system
controller when it updates the time. Set the S
ET/RUN
switch to the
RUN
position and the
UP/DOWN/CLOCK
switch
to the
CLOCK
position to return the clock display.
Setting the Up Counter Preset Time
(optional)
If you want to use the alarm and hold feature with the
UP
timer, you will need to set a preset time for the UP timer.
Set the
UP/DOWN/CLOCK
switch to the
UP
position.
Set the
SET/RUN
switch to the
SET
position. The hours digits will be flashing.
Using the
INCREMENT
switch, set the desired hours for the preset time, then press
ENTER
. The minutes digits will
now be flashing.
Set the desired minutes the same way, then press
ENTER
. The seconds digits will then be flashing.
Set the desired seconds the same way, then press
ENTER
. The display will then flash
donE
.
Set the
SET/RUN
switch back to the
RUN
position.
n
Note:
A preset of
00:00:00
allows the digital clock/timer to be used as a standard elapsed timer with a maximum
elapsed time of
30:59:59
.
