American Standard VorMax Plus 708AA Series, Руководство пользователя

Страница: 6 / 24

pg
6
9
11
From above, install mounting screws and washers (1) through
each hole, then place rubber washer (2) and plastic nut (3) from
underneath onto each bolt. Snug down but do not fully tighten.
Install VorMax Plus Housing (1)
onto VorMax Plus Base Plate (2),
snap in to secure.
Place seat onto the
protruding Base Plate
Posts and press in to “click”
into place, close seat and
cover and align seat with
bowl. Once aligned, further
tighten seat nuts under
bowl to securely hold seat
in position.
Remove seat by pressing both inside
buttons to release seat and cover:
Open Base Plate Housing Door (1). Observe the marked
notch on the VorMax Plus FreshInfuser (2). Observe the
same marked notch located on the Base Plate Housing.
Before installing, line up the marked notches on the Base
Plate Housing and the VorMax Plus FreshInfuser.
Insert the VorMax Plus FreshInfuser into the spud opening
aligning the marked notch on the VorMax Plus FreshInfuser
and the Base Plate Housing.
1
2
1
2
3
Seat Alignment
Open the seat and cover. Push both inside buttons
to release seat and cover. Pull the seat and cover
upwards to take it off the hinges.
2
Marked Notch on
VorMax Plus
FreshInfuser
Notch on Base
Plate Housing
Door
1
UNLOCKED
Marked Notch on
VorMax Plus
FreshInfuser
Notch on Base
Plate Housing
Door
2
10 12
!
CAUTION
:
IF A VORMAX PLUS FRESHINFUSER IS NOT SECURELY INSERTED INTO THE SPUD OPENING,
DO
NOT FLUSH THE TOILET
AS THIS MAY RESULT IN WATER LEAKING FROM THE TOILET.
TOILET MUST HAVE A
VORMAX PLUS FRESHINFUSER INSERTED IN THE SPUD OPENING AT ALL TIMES WHEN FLUSHING THE TOILET.
For further assistance please call Customer Care at: (800) 442-1902