Certified to comply with ANSI A112.18.1
SOAP DISH
TUMBLER/TOOTHBRUSH HOLDER
M 9 6 8 2 9 9 A
8040.050
8040.061
1
SOAP DISH and TUMBLER/TOOTHBRUSH HOLDER INSTALLATION
CARE INSTRUCTIONS:
DO:
SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT:
DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR
A CLOTH WITH A COARSE SURFACE.
2
OPTIONAL TO FINISHED FLOOR
Thank you for selecting American-Standard...the benchmark of fine
quality for over 100 years.
To ensure that your installation proceeds smoothly--please read
these instructions carefully before you begin.
Installation
Instructions
1
2
7
8
7
8
6
Regular Screwdriver
Recommended Tools
#2 Phillips Screwdriver
Drill
10'
Tape Measure
The SOAP DISH (1) and TUMBLER/TOOTHBRUSH HOLDER (2) work best if secured to a wall stud or cross brace within the wall, using the
SCREWS (3) supplied.
USE MOUNTING PLATE AS TEMPLATE
5
5
4
4
3
3
CENTER LINE
FINISHED WALL
Install the WALL ESCUTCHEON (6) onto MOUNTING PLATE (5). Place the BODIES (1,2) on the WALL ESCUTCHEON (6). Align and secure
with ATTACHMENT SCREW (7). Push in INDEX BUTTON (8) into BODIES (1, 2). Place SOAP DISH and TUMBLER into
their HOLDER to complete installation.
Determine desired height and location (optional) and mark a center line. Using the MOUNTING PLATE (5) as a template mark the two
spots for the mounting holes. If MOUNTING PLATE (5) is secured to a stud or cross brace drill small pilot holes for SCREWS (3).
For installations on drywall,
use ANCHORS (4) and SCREWS (3) for securing MOUNTING PLATE (5) to wall. Place #2 Phillips screwdriver
or cordless screwdriver into recess of anchor. Press into drywall while turning the anchor clockwise until it is seated flush with the wall.
Place MOUNTING PLATE (5) over ANCHOR
(4) and insert SCREWS (3) with #2 Phillips screwdriver. See illustration below.
Secure MOUNTING PLATE (5) to wall with SCREWS (3).
For installations on tiled walls,
pre drill a 1/4" hole through the tile only.
Do not drill into the drywall.
Use ANCHORS (4) and
SCREWS (3) for securing MOUNTING PLATE (5) to tiled wall. Place #2 Phillips screwdriver or cordless screwdriver into recess of anchor.
Press into drywall while turning the anchor clockwise until it is seated flush with the tiled wall. Place MOUNTING PLATE (5) over
ANCHORS
(4) and insert SCREWS (3) with #2 Phillips screwdriver. See illustration below. Secure MOUNTING PLATE (5) to wall
with SCREWS (3).
