American Megatrends MegaRAID Express 500, Руководство по оборудованию

Страница: 67 / 118

Chapter 6 Hardware Installation
53
Step 1 Unpack
Unpack and install the hardware in a static-free environment. The MegaRAID
Express 500 controller card is packed inside an anti-static bag between two
sponge sheets. Remove the controller card and inspect it for damage. If the card
appears damaged, or if any item listed below is missing, contact American
Megatrends or your MegaRAID OEM support representative. The MegaRAID
Express 500 Controller is also shipped with the following on CD:
•
the MegaRAID Configuration Software Guide
•
the MegaRAID Operating System Drivers Guide
•
the MegaRAID Express 500 Hardware Guide
•
the so
ftware license agreement
•
the MegaRAID Express 500 Configuration Utilities for DOS
•
the warranty registration card
Step 2 Power Down
Turn off the computer and remove the cover. Make sure the computer is turned
off and disconnected from any networks before installing the controller card.
Step 3 Configure Motherboard
Make sure the motherboard is configured correctly for MegaRAID Express 500.
MegaRAID Express 500 is essentially a SCSI Controller. Each MegaRAID
Express 500 card you install will require an available PCI IRQ; make sure an
IRQ is available for each controller you install.