Page 1 of 3
11775 E. 45th Ave. Denver, CO 80239 Ph: 1-800-880-1180 Fax: 303-695-7633
120V
4 Channel DMX Decoder
INSTALLATION INSTRUCTIONS
120-CTRL-4CH
120V
©2022 American Lighting, Inc. REV2212 www.AmericanLighting.com
SAFETY INFORMATION
• Read all instructions before beginning; Save these instructions for future use.
• To reduce the risk of fire, electric shock, or injury to person(s), pay close attention
to this manual and stay within its guidelines when using this product.
• This decoder is rated IP20; avoid the sun and moisture.
• Avoid using decoder in areas where extreme hot, cold, dust, or humidity exist.
• This decoder is suitable for indoor, dry locations only.
• Always be sure to mount this controller in an area with proper ventilation to
avoid overheating.
• This product has an operating temperature range of -20
°
C to 50
°
C.
• Never connect any cables while power is on and always ensure correct connections
to avoid short circuits prior to switching on. Ensure all wires and cables are secured
tightly in the connector prior to operation.
• For cleaning, use a soft, dry or damp cloth. Do not use harsh chemicals or
abrasives.
• This decoder is rated for 100-240V AC input.
• This decoder has 4 output terminals rated for 100-240V DC, 1.66A/96-192W each.
These products may represent a possible shock or
fire hazard if improperly installed or attached in any
way. Products should be installed in accordance
with these instructions, current electrical codes,
and/or the current National Electric Code (NEC).
This decoder requires a 100-240V AC power
suource. Disconnect supply power at the source
prior to installation.
INSTALLING Decoder (SEE FIGURE 1):
This decoder requires a 100-240V AC power source.
This decoder requires a DMX master control (not included).
1. Determine desired location of decoder. Mounting tabs on either end of the decoder may be utilized to secure decoder in place via screws.
2. This decoder has 4 x 1.5A current output channels that can be used with single color, Tunable CCT, RGB, or RGBW fixtures. Wire the decoder
to a fixture by following the fixture’s instruction manual and wiring diagrams, ensuring to match polarity (wiring varies depending on product).
Connect fixture wiring prior to bringing any power to the system.
3. Bring 100-240V AC supply power to the decoder (See Figure 1).
WARNING
WARNING
FIGURE 1
D+
D-
GND
DMX51 2 signa l input
Commo n Anod e )
CH 3:B/WW output(- )
CH 1:R/WW output(-)
CH 2:G/C W output(-)
AC100-240V
powe r input
D+
D-
GND
DMX51 2 signa l input
IP67
PRI:
Uin=100-240V AC
Iin=6 A Max
Blac k
Gre y White
Green
GND
D+
D-
DMX INPUT&OUTPU T
Blac k
Red
Gree n
Yello w
Whit e
V+
1-
2-
3-
4-
R-
G-
B-
W-
WW-
CW-
WW-
CW-
LED OUTPUT
ta:-2 0
℃
-+50
℃
SEC:
Uout=4x(100-240)VD C
Iout=4x1.5 A
Pout=4x(150-360)W
DM
X
IN
P
UT
DM
X
OU
TP
UT
AC
IN
PUT
DC
OU
TP
UT
CH 4:W/CW output(-)
