Interrupters User Guide
Chapter 5: Interrupter Programming
33
6.
To correct an entry while in a value field, enter the correct value over the current value. Press
DEL
to change the entry to 0.
7.
Press
ENTER
to start the interruption program or
PREV
to cancel.
When the interruption program begins, a screen similar to the following example displays.
The screen displays while the interruption program is running.
Figure 5-3. Interruption Program Selected
When the interruption program starts, you can either press
1
to view the Program Setup
screen or
2
to monitor the GPS status. Press
PREV
to return to the Program Selected screen.
8.
To stop the interruption program from running, press
PREV
and then
ENTER
to confirm. If
ENTER
is not pressed within a few seconds, the interrupter returns to the interruption
program.
NOTE:
If the interrupter is powered off or loses power while executing an interruption program, it
will automatically continue with the same interruption program once power is restored.
Setting Up an Interference Interruption Program
The MicroMax interrupters include an interference mode that will synchronously interrupt specific
groups of rectifiers to determine the influence of each rectifier on the structure under test. Also
refer to
Interrupter Overview on page 1
for more information on the interference mode interruption
program.
Complete the following steps to set up and run an interference program on a :
1.
With the main menu displaying, press
3
on the keypad.
Figure 5-1. Interference Setup Screen
The list below describes the type of information shown on the Interference Setup screen:
Содержание MicroMax GPS360
Страница 1: ...Proven compliance solutions Relentless service Interrupters User Guide Interrupters User Guide...
Страница 5: ...Interrupters User Guide v Appendix E Regulatory Notices 63 Export Control Classification Number 63...
Страница 60: ...Interrupters User Guide Chapter 5 Interrupter Programming 55 The configuration is now complete...
