20174-4-1013
Page 4
PrOPer INSTALLATION SeQueNce:
ALS-(18, 24, 30)f2
(figure 1)
1. Place left, front (#1) log onto pins on burner pan.
2. Place right, front (#2) log onto pins on burner pan.
3. Place rear (#3) log onto pins on rear log support.
4. Place Y branch (#4) onto pins right and left front logs.
5. Compare the completed log installation with the appropriate
photo from pages 5 through 7. Review previous steps to make
any necessary adjustments.
6. Log placement is completed.
Attention:
Do not use Figure 1 to order replacement logs. Refer to
Page 8, Parts List and Parts View to order logs for your appropriate
model number.
Apply loose material (glowing embers) per appropriate Installation
Instructions and Owner's Manual. Replacement of loose material
(glowing embers) must be purchased from American Hearth
Systems, Inc. Application of excess loose material (glowing embers)
may adversely affect performance of the heater. WARNING:
All previously applied loose material must be removed prior to
reapplication.
Replacement Loose Material (glowing embers) Part Number
ALS-18F2
15999
ALS-24F2
15970
ALS-30F2
15970
Platinum Bright Embers
PE-20-1
Note:
A single layer of embers is to be used when applying Platinum
Bright Embers (alone or in combination with production embers)
to the burner.
Before you begin: Do not, handle these logs with your bare hands! Always wear gloves to prevent skin irritation. After handling logs, wash
your hands gently with soap and water.
All Logs
The positioning of the logs is critical to the safe and clean operation of this heater. Sooting and other problems may result if the logs are
not properly and firmly positioned in the appliance.
refer to figure 1 for the following warning.
warning:
Failure to position the parts in accordance with this diagram or failure to use only parts specifically approved with this
appliance may result in property damage or personal injury.
Log Placement
ALS-(18, 24, 30)f2 Logs
figure 1
The following WARNING applies when log set is installed onto an
unvented gas burner assembly.
wArNINg: This appliance is equipped for (natural or
propane) gas. field conversion is not permitted.
1
2
3
4
LOg PLAceMeNT
Scan this code to see the log assembly video.
