Installation Guide
8000-2684-01, Rev. C (2 pages)
CCTV PRODUCTS
1
1
DeltaDrone
™
II
Fixed Camera
AD614 Series
The DeltaDrone fixed camera is housed inside a
DeltaDrone housing. Two camera types are
available:
NTSC (60Hz color) and PAL (50Hz color).
Each camera has manually positioned pan and tilt
(the pan has 370° of travel) and manually set
zoom, focus, and iris. The drone camera comes
fully assembled and is simple to install.
IMPORTANT!
Anytime you are using a VM96
video controller, and the SpeedDome Ultra Drone
II camera dome is:
•
New:
Reset the VM96 to update the
configuration form to a fixed camera.
•
A replacement for the SpeedDome Ultra
camera dome:
Delete the SpeedDome Ultra
configuration form as explained in the VM96
Administrator’s Manual 8000-0756-05. Then
reset the VM96 to update the configuration
form to a fixed camera.
Procedure
The following steps refer to figures opposite:
1. Attach camera dome to base containing a
pigtail connector or I/O board.
a. Align recessed dimple on cap of dome with
red dot on base (pigtail) or logo visible on
I/O board.
b. Mate housing and eyeball assembly to base
and turn it clockwise until you hear a click.
Notes:
This is a fixed camera, no data lines are required.
If connecting to a pigtail base, an LED at top of
dome housing indicates 12V power. This LED
cannot be seen after connection to the I/O board.
2. As shown on page 2, turn eyeball if necessary
to access slot cover containing lens. Unsnap
this cover by gently tugging it away from
eyeball.
3. You now have access to the camera set screw.
To access lens adjustments, loosen set screw
and gently pull camera out until screw reaches
front end of slot. Retighten set screw.
1a
LATCH
1b
Pigtail Connections (9-pin connector)
Pin
Color
Designation
1–2
N/A
Not used.
3
Black
24Vac
4
Red
Ground
5
White
24vac
6–9
N/A
Not used.
I/O Board Connections (connector P7)
Pin
Color
Designation
1
Black
24Vac
2
Red
Ground
3
White
24vac
Power
LED
