©
American DJ
®
- www.americandj.com - Fire Fox Instruction Manual Page 5
©
American DJ
®
- www.americandj.com - Fire Fox Instruction Manual Page 6
Fire Fox Fuse & Lamp Replacement
Fire Fox
Operation
Power Supply:
Before plugging your unit in, be sure the source
voltage in your area matches the required voltage for your American
DJ
®
Fire Fox before attempting operation.
General Operation:
Just plug this light in, and watch it go. This fix-
ture is designed to operate as a stand alone unit. It has been tested
and the lamp has been installed at the factory there is no assembly
necessary. The Fire Fox is ready to be plugged in, out of the box.
There is no power switch, after plugging the unit the unit’s internal
beveled glass wheel will rotate continuously in a single direction. If
there is no lamp output check the fuse and bulb. If the fuse and bulb
are good, please return the unit for servicing.
Focusing:
The unit has a fully focusing lens. The lens is focused by manually
turning the lens in either a clockwise or counter-clockwise direction.
Caution:
Always replace with the exact same type lamp and fuse,
unless otherwise specified by an authorized American DJ
®
techni-
cian. Replace with anything other than the specified part can damage
your unit and will void your manufactures warranty.
Warning:
If after you have replaced the lamp or the fuse and you
continue to blow either one, STOP using the unit. Contact customer
support for further instructions, you may have to return the unit for
servicing. Continuing to use the unit may cause serious damage.
Fuse Replacement:
First unplug the power. Locate the unit’s power
cord. The fuse holder is located above the power cord. Using a flat-
head screw driver unscrew the fuse holder. Remove the bad fuse and
replace with a new one.
Lamp Replacement:
Caution! Never open the unit when in use.
Always disconnect the main power and allow the fixture ample time
to cool before attempting to replace the lamp. Lamp replacement has
been made simple by incorporating a split dome that is retained by
thumb screws.
Again, please remember to always replace with the
exact same type lamp.
1. Be sure to follow the proper procedures when handling halogen
lamps.
Never touch the new lamp with your bare fingers.
2. Unscrew the single thumb screw located at the back of the
unit.
3. Once the thumb screw has been removed, remove the lamp
cover plate to expose the lamp.
4. Remove and replace the lamp with an exact match.
5. Reassemble in reverse order.
Halogen Lamp Warning!
This fixture is fitted with
halogen lamps which are highly susceptible to
damage if improperly handled. Never touch the
lamps with your bare fingers as the oil from your
hands will shorten lamp life. Also, never move the
fixture until the lamps have had ample time to cool.
Remember, lamps are not covered under warranty
conditions.
