Installation and Operating Instructions for the iAdapter™6
Designed by AMDi
www.amdi.net
Loosen the 12 (twelve) screws from the back of
the iAdapter™ as shown in the picture below.
These screws are captive screws and will not fall
out after you loosen them and turn the bottom
housing over.
Place the iPad™ onto the 8 (eight) rubber
supports inside the iAdapter™. The rubber
supports are color coded for the different iPad’s.
Pink is for iPad versions 2 through 4 with Retina
Display. Green is for the iPad Air and Yellow is for
the iPad Air 2.
Make sure that the reset button of the iPad®
lines up with the reset button of the iAdapter™
as shown in the picture to the right.
Place the top housing of the iAdapter™ over the
iPad®. Align the top housing of the iAdapter™
with the bottom housing of the iAdapter™.
Carefully hold both the top and the bottom
housing of the iAdapter™ together and then turn
it over onto a flat surface. Tighten the 12
(twelve) screws that will hold the iAdapter™
together.