6
To access the reset button and to adjust the camera angle, use a Torx/Hex wrench to open the camera assembly by
removing the 3 screws.
For reference, a Torx/Hex screwdriver tip looks like this:
3 Connection & Installation
This section provides information about the connection and installation of your camera.
3.1 Connection Guide
The camera initially should be connected via the following method:
This camera uses a POE cable to enable connection to the camera via a PC, as well as to power the camera.
3.2 Installation Guide
To install the camera on a ceiling or wall, please reference the below diagram as well as the steps:
Note
: Prior to installation, please ensure that the installation environment can support at least 3x the weight of the
bracket.
Note:
Due to certain hardware limitations within your camera it is important to note that these devices will
not
be
able to automatically/remotely pan/tilt or pivot in either the app or via the web UI on a computer. For this reason, it
