AMCI SD17060E2, Руководство пользователя

Страница: 35 / 144

20 Gear Drive, Plymouth Ind. Park, Terryville, CT 06786

Tel: (860) 585-1254 Fax: (860) 584-1973 http://www.amci.com
Networked Indexer/Driver User Manual
M
OTION
C
ONTROL
35
Assembled Moves (continued)
Blend Move (continued)
1) You do not have to preset the position or home the machine before you can use a Blend
Move. Because the Blend Move is based on Relative Moves, it can be run from any location.
2) The Blend Move is stored in the internal memory of the Networked Driver and can be run
multiple times once it is written to the unit. The Blend Move data stays in memory until
power is removed, the unit is sent new Configuration Data, or a new Blend or Dwell Move is
written to the unit. As described in
Saving an Assembled Move in Flash on page 37, it is
also possible to save a Blend Move to flash memory. This move is restored on power up and
can be run as soon as you configure the Networked Driver and enter Command Mode.
3) There are two control bits used to specify which direction the Blend Move is run in. This
gives you the ability to run the Blend Move in either direction.
Controlled Stop Conditions

The move completes without error.

You toggle the Hold_Move control bit in the Network Output Data. When this occurs, the Networked
Driver decelerates the move at the deceleration rate of the present segment to the Starting Speed and
ends the move. Note that your final position will most likely not be the one you commanded. A Blend
Move that is brought to a controlled stop with the Hold_Move bit cannot be restarted. The use of the
Hold_Move bit is explained in the
Controlling Moves In Progress section starting on page 40.
Immediate Stop Conditions

The Immediate_Stop bit makes a 0

1 transition in the Network Input Data.

A positive transition on an input configured as an E-Stop Input.

A CW or CCW Limit Switch is reached. If the limit that is reached is the same as the direction of travel,
for example, hitting the CW limit while running a CW move, a
Reset Errors command must be issued
before moves are allowed in that direction again. If the limit that is reached is opposite the direction of
travel, a
Reset Errors command does not have to be issued.
Dwell Move
A Dwell Move gives you the ability to string multiple relative moves together and run all of them sequentially
with a single start condition. Like a Blend Move, a Dwell Move is programmed into a Networked Driver as a
series of relative moves before the move is started.
Unlike a Blend Move, the motor is stopped between each segment of the Dwell Move for a programed Dwell
Time . The Dwell Time is programmed as part of the command that starts the move. The Dwell Time is the same
for all segments. Because the motor is stopped between segments, the motor direction can be reversed during
the move. The sign of the target position for the segment determines the direction of motion for that segment.
Positive segments will result in clockwise shaft rotation while a negative segment will result in a counter-clock-
wise shaft rotation.