50D0093 Rev 3 May 2005
Page 6 of 11
Ambient Technologies
A Division Of
Transmitter:
General:
The TLT has two operating modes. It can used as manual or thermostatic On/Off remote control system.
The transmitter will operate the remote receiver from 1foot to a maximum of 20 feet. The operational range is
reduced when batteries are low or when the receiver is inside a metal enclosure.
Initial start up:
1.
After initial power up or reset button is pressed, the transmitter is reset.
2.
During transmitter reset, all segments of the LCD will be turned on. After ten (10) seconds, the LCD will
be initialized and operational. You will hear a beep during this time.
3.
After reset, only the room temperature will be displayed on the LCD display.
Manual Mode- On or Off Operation:
1.
Since Touch Light transmitter is touch sensitive equipment, we recommend to use only your index finger to
touch. Do not use any metal object to contact or touch the surface. The transmitter will recognize a valid
touch if either side of the surface area are covered more than 10% for a period of
at least 1 second
2.
To activate a signal, you need to touch either side of the groove surfaces for
at least 1 second
and then
release your finger. If the touch is valid, it will beep once and a signal will be sent to the receiver. During
this time you will see the transmission icon on the LCD display for a brief time.
No other command can
be given until the transmission is completed.
