Version 1.10
©Copyright 2013, Ambient LLC. All Rights Reserved.
Page 6
decreases the transmission range by the factor shown below.
Medium
RF Signal Strength Reduction
Glass (untreated)
5-15%
Plastics
10-15%
Wood
10-40%
Brick
10-40%
Concrete
40-80%
Metal
90-100%
4
Console Operation
Note:
The console has four keys for easy operation:
SET
key,
ALARM
key,
MIN/MAX
key and
+
key. There are four program modes: Quick Display Mode, Set Mode, Alarm Mode and Min/Max
Mode.
Any program mode can be exited at any time by either pressing the
SNOOZE/LIGHT
key (on the top
of the display console), or waiting for the 10-second time-out to take effect.
4.1 Quick Display Mode
A quick reference guide for the Quick Set Mode is available in Section 13.1.
While in Normal Mode, press the
SET
key to enter the Quick Display Mode as follows (once for
outdoor temperature and dew point and twice for absolute pressure and relative pressure):
1.
Display Outdoor Temperature and Dew Point
. Press the
MIN/MAX
or
+
key to toggle
between outdoor temperature and dew point.
2.
Absolute Pressure and Relative Pressure
. Press the
MIN/MAX
or
+
key to toggle between
absolute pressure and relative pressure.
4.2 Set (Program) Mode
A quick reference guide for the Set Mode is available in Section 13.2.
While in Normal Mode, press and hold the
SET
key for at least three seconds to enter the Set Mode.
The first setting will begin flashing. You can press the
SET
key again to skip any step, as defined
below.
Note:
In the Set mode, press the
+
key or
MIN/MAX
key to change or scroll the value. Hold
the
+
key or
MIN/MAX
key for 3 seconds to increase/decrease rapidly.
Note:
Press the
SNOOZE
key (or wait 30 seconds for the programming mode to timeout), and
the Set Mode will return to Normal Mode.
1.
Daylight Savings Time (DST)
. The
DST
(ON or OFF) setting will begin flashing. Press the
+
key to toggle between DST ON and DST OFF.
2.
Time Zone Settings
. Press the
SET
key again to adjust the Time Zone (TZ) setting.
