Version 2.0
©Copyright 2017, Ambient LLC. All Rights Reserved.
Page 2
1.
Introduction
Thank you for your purchase of the Ambient Weather WS-0262 WiFi Wireless Thermo-Hygrometer.
The following user guide provides step by step instructions for installation, operation and
troubleshooting. To download the latest manual and additional troubleshooting tips, please visit:
http://ambientweather.wikispaces.com/ws0262
2.
Getting Started
The Ambient Weather WS-0262 WiFi Wireless Thermo-Hygrometer consists of an indoor display
console (re WiFi transmitter) and an indoor / outdoor thermo-hygrometer.
2.1
Parts List
QTY
Item
1
Display Console
Dimensions (LxHxW): 67.5 x 90 x 26.8 mm (2.65 x 3.54 x 1.06”)
1
Thermo-hygrometer transmitter (WH32E)
Dimensions (LxHxW): 122 x 40 x 18 mm (4.80 x 1.57 x 0.71”)
1
5V DC Adaptor
1
User manual
2.2
Indoor / Outdoor Thermo-Hygrometer Setup
Note:
To avoid permanent damage, please take note of the battery polarity before inserting the
batteries.
1.
Remove the battery door on the back of the sensor (Figure 1a).
2.
Insert 2 x AA batteries
3.
After inserting the batteries, the remote sensor will display temperature and humidity on the
display, as shown in Figure 1b.
4.
Close the battery door.
Note:
We recommend lithium batteries for cold weather climates, but alkaline batteries are sufficient
for most climates. We do not recommend rechargeable batteries. They have lower voltages, do not
operate well at wide temperature ranges, and do not last as long, resulting in poorer reception.
Note:
The outdoor humidity is displayed on the remote sensor, on the Internet (AmbientWeather.net
and Wunderground.com) but not displayed on the receiver to reduce the cost of the console.
