CARE AND MAINTENANCE
Spiders and insects can nest in burner or orifices. This dangerous condition can damage fire feature
and render it unsafe for use. Clean burner holes by using compressed air, burner is fragile, handle
with care when cleaning.
Carbon deposits may create a fire hazard, to clean, remove the emitter grid (mesh) assembly, take
down one side of protective guards. Then take the glass tube UP AND THEN OUT from the
Ambiance Fire Feature wash and clear. After that; reassemble the glass tube and the rest of parts.
Note:
In a salt-air environment (such as near an ocean), corrosion occurs more quickly than normal.
Frequently check for corroded areas and repair them promptly.
TIP:
Use high-quality automobile wax to help maintain the appearance
of your fire feature. Apply to exterior surfaces from upper support
(long) down. Do not apply wax to emitter grid, glass tube, or
reflector.
Storage, Transporting or during periods of extended inactivity
Between uses:
Turn control knob OFF.
Disconnect LP cylinder.
Store fire feature upright in an area sheltered from direct contact with inclement weather (such as
wind, rain, sleet, hail, snow, dust and debris).
If desired, cover fire feature to protect exterior surfaces and to help prevent build-up in air passages.
Note:
Wait until fire feature is completely cooled off before moving or covering.
Service
Only a qualified service person should repair gas passages and associated components. Contact
AEI Corporation for OEM parts at:
Ph (949) 474-3070 Fax (949) 474-0559
www.aeicorporation.com
or
2641 Du Bridge Ave., Irvine CA 92606
Caution: Always allow fire feature to cool before moving or attempting service.
20
Spiders and other small insect are attracted to the odorant found in gas.
Keep area in and around Ambiance Fire Feature Free from insects.