ASSEMBLY INSTRUCTIONS
11. Assemble the protective guard and mesh
by inserting the hooks of protective guard (F)
to the holes of upper supports (E).
Put the mesh (B) on the top plate (D). Make sure
the screw holes align the holes of top plate (D).
Use Phillips screwdriver (LL) to secure the
mesh (B) and
protective guard (F) to the top
plate (D) with M5 x 12 mm screws (DD) and
fixing bracket (FF).
Hardware Used
DD
M5 x 12 mm Screw
x 3
FF
Fixing Bracket
x
3
LL
Phillips
x
1
Screwdriver
12. Carefully lean the assembly and attach
reflector (A) to mesh (B) with studs (CC),
small flat washers (BB) on either side of
reflector (A) and then wing nuts (AA). Gently
return the assembly to the upright position.
Hardware Used
AA
Wing Nut
x 3
BB
Small Flat
x 6
Washer
CC
Stud
x 3
11
F
B
FF
DD
12
AA
A
BB
CC
11
E
