56
Maintenance
20.11 Replacing the Pilot
Before you begin:
•
Ensure the fireplace is off and cool before servicing.
•
Disconnect power supply (including battery backup) to the
fireplace and turn off gas supply.
•
Remove the fireplace surround. See
Section 16.0
.
•
Remove barrier screen. See
Section 14.0
.
•
Remove door assembly. See
Section 15.0
.
•
Remove burner media. See
Section 18.0
.
•
Remove panel set (if applicable). See
Section 17.0
.
•
Remove the burner. See
Section 20.10
.
•
Disconnect venting and remove the insert from the masonry
opening
2. Remove the (2) tek screws securing the pilot to the extrusion.
1. Unplug the pilot wires from the control board.
Figure 20.11.01:
Figure 20.11.02:
3. Disconnect the pilot gas line from the pilot assembly.
Figure 20.11.03:
4. Remove the screw securing the pilot ground wire.
Figure 20.11.04:
5. If necessary, the pilot gas line may be removed from the valve
on the left side of the fireplace.
Figure 20.11.05:
7. Installation is the reverse of removal. Light the fireplace and
verify proper operation and flame pattern according to
Section
20.4
and
Section 20.5
of this manual.
Содержание Inspiration 29
Страница 66: ...NOTES...
Страница 68: ......