Syntax: SET ZONE 3
SET DST #
Sets the receiver to Daylight Saving Time or to Standard Time.
0 = Standard Time (No DST) – used for those who do not participate in DST, e.g.
Arizona. The time will not change when DST goes into effect or when it ends.
1 = If your locality observes Daylight Saving Time (DST) and your receiver needs to
adjust for that.
Syntax: SET DST 0
Network Commands
DHCP ON/OFF
This turns DHCP ON or OFF. When DHCP is on the IP address of the receiver is selected
automatically by a DHCP Router. That is usually in a router or high-speed (DSL or cable)
modem.
Syntax: DHCP ON or DHCP OFF
NEWIP #.#.#.#
This allows you to set the IP address of the AMR-100-I receiver. Your network administrator
must provide this address if DHCP is set to OFF.
Syntax: NEWIP 192.168.1.145
NEWNETMASK #.#.#.#
The Netmask is a filter that rejects or accepts communications from other computers on the
network. Normally this is 255.255.255.0 and it accepts all communication with the first three
set of numbers that match the computers IP address. Thus an IP address of 192.168.1.100
with a Netmask of 255.255.255.0 will accept communication from any computer on the
network that has an IP address in the range of 192.168.1.0 to 192.168.1.255.
Syntax: NEWNETMASK 255.255.255.0
NEWGATEWAY #.#.#.#.
Sets the Internet gateway of your network. This is usually the address of the router or high-
speed modem. Your network administrator needs to provide that information if DHCP is
OFF.
Syntax: NEWGATEWAY 192.168.1.1
Rev. 1 – Firmware version 2.03
46
©
2012