Trigger Event Lists
This link takes you to a page listing events that happen
on an input closure or on a command sent by satellite or
serial port. The system calls these trigger events. If an
event happens on a closure sent by a program producer,
then it will have a serial string that causes a program or
spot to air. This text is listed. If an input closure is used,
they are described as Input 1, Input 2, Input 3 or Input
4. There can be a maximum of 100 triggers, but only
those that are used are listed. The example to the right
shows six trigger events.
Clicking on one of the events is shown in the following illustrations. The first one shows a
trigger based upon a text command sent to the receiver. Notice that it has the same
information as the Scheduled event. However, the chart does not populate until the text has
been sent and the trigger has caused a file to play.
The following illustration shows an input closure trigger.
Rev. 1 – Firmware version 2.03
43
©
2012