Amazone Tyrok 400, Оригинальное руководство по эксплуатации

Страница: 60 / 108

10. Select working width on the running gear via the
peg hole.
11. With the pin, peg the strut in the selected peg
hole.
TROUBLESHOOTING
Is the peg hole visible?
1.
To use the selected peg hole,
if necessary move the coupled implement
slightly forward or back.
12. Secure pin with threaded union.
50 cm
45 cm
35 cm
40 cm
CMS-I-00004908
6.3.2 Adjusting the tilt angle of the plough relative to the tractor
During operation, the plough runs perpendicular to
the unploughed soil. To do so, the tilt of the plough to
the tractor must be adjusted.
The spindles serve as a stop for the plough in
working position.
Adjust the tilt angle with the spindle on both sides
consecutively.
The tilt angle depends on the adjusted working
depth.
90°
+
-
CMS-I-00003708
REQUIREMENTS
Implement is parked or in working position
First adjust the exposed tilt adjustment element:
1. Lift adjustment bracket.
2.
To increase the tilt angle,
turn the stop
1
upward via the adjustment
bracket
or
To reduce the tilt angle,
turn the stop downward via the adjustment
bracket.
3. Secure the adjustment bracket in parking position
with the locking ring.
> 5 mm
1
CMS-I-00004914
CMS-T-00006530-A.1
6 | Preparing the machine
Preparing the implement for operation
MG7196-EN-GB | G.1 | 26.07.2022 | © AMAZONE 54