13.
If the conveyor hoses are sagging,
fasten the fertiliser hoses.
14.
When the implement sections have reached the
end position,
release the pull rope and move the "green" tractor
control unit to the neutral position.
6.5.27 Adjusting the coulter pressure in the track
1.
Switch on the fan.
2.
To set the coulter pressure beside the tracks to
zero:
Refer to the ISOBUS operating manual,
"Adjusting the coulter pressure".
CAUTION
Risk of tripping due to difficult
access
For safe access,
use a platform ladder.
Additional coulter pressure can be applied onto the
coulters in the track. The additional coulter pressure
can be set between 10 bar and 50 bar.
3.
To adjust the additional coulter pressure in the
track:
put the coulter pressure in the desired position on
the setting screw
1
.
The pressure gauge
2
shows the additional
coulter pressure in the tractor tracks.
When the coulter pressure beside the tracks is
adjusted, the coulter pressure in the tracks is
increased by the set value.
4.
To check the setting after driving a short
distance:
See "Checking the placement depth".
+
-
1
2
CMS-I-00005532
CMS-T-00007947-C.1
6 | Preparing the machine
Preparing the implement for operation
MG6149-EN-GB | J.1 | 18.10.2022 | © AMAZONE
152
