Amazone Centaya 3000 Special, Оригинальное руководство по эксплуатации

Страница: 132 / 160

1. Slightly raise the implement.
2. Determine the diameter of the RoTeC cutting
discs.
3.
If the diameter of a cutting disc is smaller than
the wear limit from the table,
replace the RoTeC cutting disc.
4.
To replace the RoTeC cutting disc,
remove the bolts
2
on the front side of the
cutting disc.
5. Replace the worn RoTeC cutting disc
1
.
6. Install the bolts.
2 1
CMS-I-00005324
10.2.9 Checking the tightening torque for the radar sensor bolts
INTERVAL
After initial operation
Every 12 months
NOTE
When the tightening torque is too high, the spring-
suspended sensor mount is warped and the radar
sensor does not work properly.
Check the tightening torque on the radar sensor.
CMS-I-00002600
CMS-T-00002383-E.1
10 | Repairing the implement
Maintaining the implement
MG7508-EN-GB | B.1 | 31.08.2022 | © AMAZONE 126