9.
Install the wheel mark eradicator bracket
2
rotated by 180 degrees.
10. Install the nuts for the clamp connection
3
.
11. After 5 hours of operation, check the bolt
connection for tight fit.
2
1
CMS-I-00003337
12. Fasten the wheel mark eradicator
1
in the
bracket with the locking pins
4
.
13. Secure the locking pins with the linch pins.
14. Move the wheel mark eradicator to the desired
position.
15. Secure the wheel mark eradicator with the locking
pin
2
.
16. Secure the locking pin with the linch pin
3
.
1
3
4
2
CMS-I-00003339
8.2 The wheel mark eradicator tool carriers are constantly working in the soil horizon.
Due to wear on the rotating tines, the working depth of the soil tillage implement must be
corrected. The wheel mark eradicator brackets are too close above the soil.
IMPORTANT
The tool carriers become worn when
constantly working in the soil.
Install the wheel mark eradicator bracket
at a higher position.
1.
To prevent the tool carriers
1
from constantly
working in the soil horizon,
rotate the wheel mark eradicator bracket
2
by
180 degrees.
2
1
CMS-I-00003334
CMS-T-00005077-A.1
8 | Eliminating faults
MG6158-EN-II | H.1 | 30.04.2021
56
