Thank you for choosing DUNE RUNNER™. With proper care, your new
DUNE RUNNER™ will provide you with many hours of enjoyment. Please read this
instruction manual completely before using the product for the first time, and then
keep this manual in a handy place for future reference.
Colors and styles may slightly vary.
SAFETY WARNINGS!
•
Improper use of batteries may lead to overheating, breakage or leaking.
-
Do not mix old and new batteries.
-
Do not mix different battery brands.
-
Install batteries with correct polarity. The flat side (negative terminal) of the battery should rest
against the spring.
-
Remove dead batteries immediately.
-
Avoid liquids, which can short circuit the batteries.
-
The truck or remote will become unresponsive when batteries are low, at which point you should replace
all batteries with new ones.
-
Remove the batteries if you will not use the truck for a long time.
•
Avoid using near furniture or glass to prevent damage to these objects.
•
Do not play on roads.
•
Do not play in crowded areas to avoid injury or damage. Choose a safe location away from traffic.
•
Do not use truck during a storm or when lightning or thunder are present.
•
Do not use in a wet , sandy or muddy environment as truck may become damaged.
•
Do not modify or attempt to replace the built-in original antenna on the remote or truck. Doing so will damage the
set and affect operation.
• Do not pull on any wires that are part of the truck. Such action may cause the wires to break and the truck
to malfunction.
• Keep fingers, hair and clothes away from the truck’s spinning tires. Failure to do so may result in
physical injury.
• Never aim the truck at other people.
• Do not throw the truck or purposely hit it with any object.
• Store truck in a cool environment, away from high-temperature sources such as fires, stoves, radiators, etc.
• This truck has no user-serviceable parts. Do not attempt to modify components or circuit board.
INSTRUCTION MANUAL
STEERING WHEEL TRIM ADJUSTMENT
WARNING
DO NOT USE TRUCK IN INCLIMATE WEATHER!
TROUBLESHOOTING
Before sending your truck in for repair, please check for a solution below.
Problem
Truck will not move.
Truck does not respond properly to
remote control.
Truck loses connection to remote
control.
Truck battery has fully charged, but
slower than normal.
Possible Cause(s)
Weak batteries; no batteries
Truck and remote not synced properly
Another RC truck may be transmitting on the
same radio frequency
Using truck in a small enclosed area
Using truck indoors
Low batteries in transmitter or vehicle
Driving truck for too long at high speeds, causing
motor to overheat
Solution
Install new batteries in remote control and
recharge the truck battery.
Refer to sync section and re-sync your truck
and remote.
Move to a new location where no other RC
trucks are present.
Move outdoors to a large open area.
Install new batteries in remote control or
recharge your truck.
Turn truck off for 10-15 minutes.
If the Truck can not go forward straightly you may need adjust the
steering wheel trim on the bottom of the truck from time to time
until the truck can go forward straight. (see diagram F)
F
BATTERY WARNING:
• Do not mix alkaline, standard (carbon-zinc) and rechargeable batteries (nickel-cadmium).
• Do not mix old and new batteries.
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the unit before being charged (if removable).
• Rechargeable batteries are only to be charged under adult supervision (if removable).
• Exhausted batteries are to be removed.
• The supply terminals are not to be short-circuited.
• Only batteries of the same or equivalent type as recommended are to be used.
• Batteries are to be inserted with the correct polarity.
LITHIUM BATTERY STATEMENT:
• Battery may explode or leak chemicals if opened, exposed to fire or high temperature, installed backwards,
or mixed with other battery types.
For further information please send all inquiries to [email protected]
Dune Runner™ is the registered trademark of Amax Group USA, LLC.
AMAX Group USA Address: 12645 Memorial Dr Suite F1 #388 Houston, TX 77024
All Rights Reserved. visit us at www.amaxbrands.com
Made in China
C011-USA-V1.0
Limited 90-Day Warranty
NORTH AMERICA
AMAX Group USA warrants to the original consumer that this product is free from any
electrical or mechanical defects for a period of 90 DAYS from the date of purchase. If any such
defect is discovered within the warranty period, AMAX Group USA will repair or replace the
unit free of charge upon receipt of the unit, shipped postage prepaid and insured to our
warranty center ALONG WITH THE ORIGINAL RECEIPT evidencing that the product was
purchased from an approved AMAX retail partner and that the product is still within the 90
day warranty period. The warranty covers normal consumer use and does not cover damage
that occurs in shipment or failure that results from alterations, accident, misuse, abuse,
neglect, wear and tear, inadequate maintenance, commercial use or unreasonable use of the
unit. Removal of any parts/components voids all warranties. This warranty does not cover
cost of repairs made or attempted outside by third-party individuals or companies. Any
applicable implied warranties, including warranties of merchantability and fitness, are hereby
limited to 90 DAYS from the date of purchase. Consequential or incidental damages resulting
from a breach of any applicable express or implied warranties are hereby excluded. Some
states do not allow limitations on the duration of implied warranties and do not allow
exclusion of incidental or consequential damages, so the above limitations and exclusions in
these instances may not apply.
REPAIR/REPLACE PRODUCT
If your product begins to malfunction or stop working, immediately contact our warranty
center (contact details listed below). If it is determined that a return is necessary, our warranty
department will issue you an RMA number/form and an address to the nearest return center
for shipping the product to us. When honoring the warranty, AMAX reserves the right to
either repair, replace or refund the product.
IMPORTANT NOTICE:
We will reject and return to sender returns that are not accompanied by an AMAX issued
RMA form and RMA number so make sure to contact our warranty center before attempting
to return your product!
PREPARATION FOR SHIPPING YOUR PRODUCT:
Please repack your product in a durable box, preferably in the original carton, and send it
prepaid, and adequately insured. Include the RMA form that was issued by our warranty
department along with your daytime telephone number and email address inside the
shipping carton. If your warranty has expired and you still require service please contact our
customer care team For further information please send all inquiries to:
[email protected]
IMPORTANT NOTICE!
DO NOT ATTEMPT TO SHIP YOUR PRODUCT BACK
WITHOUT FIRST CONTACTING OUR WARRANTY
DEPARTMENT AT:
www.amaxbrands.com
Email: [email protected]
FCC Part 15 C Notice
CAUTION:
Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions :
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
Conforms to safety requirements of ASTM, FCC and CPSIA.
