AMANO Europe NV, Westerring 2, 3600 Genk, Belgium
Tel: +32 89 32 39 20, Fax: +32 89 30 69 47
C
onfiguration
G
uideline HT503
10
10
6
Configuration of Xparc Server (via Xoffice)
The Xparc server also need to know that the Grandstream FXO is used for intercom
forwarding. The following steps have tob e taken to enable the device in your Xparc
system.
6.1
Xparc Module
You have to enable Xparc module 109 (Intercom forwarding to analog line)
When enabled the system will automatically configure the Xparc PBX to allow the ID
1001 to connect.
6.2
Configuration Parameters
You also have to configure 2 configuration parameters.
1)
Set parameter 2 to HT503
2)
Set parameter 3 to Intercom forward by Asterisk
6.3
Activate Configuration
Activate configuration to make new configuration active and logout in Xoffice.
6.4
Configure Intercom Forwarding
Once the parameters are set as explained above and activated you have to logout
and login at Xoffice to see the new menu layout for intercom forwarding.
Now configure the telephone numbers you want to forward the calls to as usual in
the Intercom Forwarding menu.
6.5
Activate Tariff
Finally activate tariff and test the forwarding