Amanda Amanda@Work.Place Version 3.xx, Руководство по установке

Страница: 29 / 206

Chapter 5: Defining Tone Patterns 21
8. After AccuCall Plus has determined the system tone pattern, you can customize the
tone description using the Edit Tones box:
Name: Example: Panasonic Double Ring
Type: Ring1 if single ring, single pause
Ring2 if double ring, single pause
Terminating: NO
Cadence: NO
Frequency1: Determined by test
Frequency2: Determined by test
PCPM Code: 8 (always for ring tones)
Quick Count: None
On Time: Determined by test
On Max Variation: Determined by test
On Min Variation: Determined by test
Off Time: Determined by test
Off Max Variation: Determined by test
Off Min Variation: Determined by test
9. Save the tone by pressing F8 (twice).
10. From the main screen, press F3 to go to the Filters screen. The Undefined Tone Fre-
quencies box on the right side of the screen lists any undefined frequencies that were
found by the test.
11. Add these frequencies to the Filter table on the left side. Write each frequency in the
Filter table, replacing the word “none” with the frequency.
12. Then press F10 to save this information and return to the main screen.
N
OTE
: All the listed frequencies must be at least 40 Hz apart so Amanda can
distinguish them.
To define the Busy tone pattern:
1. Fill in the telephone number for an extension that is offhook and connected to either
another internal extension or to an outside line.
2. Type 3 in the Verification Count field. This is the number of times you want to run the
test.
3. Type 10 in the Minimum Cycles field. This is the number of rings AccuCall Plus will
listen to before completing the test cycle.
4. Select Full (the default) as the value for the Frequency Range field.
The possible values are:
Full (300 Hz to 1700 Hz)
High (800 Hz to 1700 Hz)
This is the range of frequencies that AccuCall Plus listens to.