Amanda Amanda@Work.Place Version 3.xx, Руководство по установке

Страница: 181 / 206

Appendix C: Configuration Reference 173
tmo_dtmf The amount of time Amanda waits after a DTMF digit before deciding the caller has fin-
ished the entry. (If the caller presses #, Amanda immediately recognizes this as the end
of a DTMF entry.)
Number of tenths of seconds (from 1 to 255). The default is 12 (1.2 seconds).
The default appears in install.cfg as:
set tmo_dtmf 12
tmo_hold Determines how long Amanda waits after a caller presses * to hold for an extension that
is busy before trying to transfer the call again. This is only used when the file
C:\AMANDA\HOLD.VOX, which Amanda normally plays for callers on hold, is miss-
ing. Usually Amanda tries to transfer the call after playing the file.
Number of seconds. The default is 20. The range is 0 to 255.
N
OTE
:
You can record over HOLD.VOX using the system administration menu from the system
administration mailbox (mailbox 999.) You may want to save the original first.
The default appears in install.cfg as:
set tmo_hold 20
tmo_idle Number of seconds of inactivity after which Amanda decides that the port is idle.
The default is 0. The range is 0-999.
When greater than 0, Amanda goes off-hook and back on-hook after deciding that the
port is idle. This is necessary when a telephone system does not release a station that is
connected to Amanda even after Amanda has gone on-hook (a rare occurrence).
When 0, Amanda does not go off-hook and back on-hook if a port is idle.
The default appears in install.cfg as:
set tmo_idle 0
tmo_integrate During inband integration, this option causes Amanda to wait the specified number of
seconds for the first digit to arrive. Then the seconds in the timeout period (specified in
the .pbx file) begin. After the first digit arrives, Amanda continues to read digits until
the timeout period ends.
The range is 0 to 255. The default is 0.
The default appears in install.cfg as:
set tmo_integrate 0
tmo_menu The amount of time Amanda waits before repeating a menu when no selection is made.
Number of tenths of seconds from 1 to 99. The default is 20 (2.0 seconds).
The default appears in install.cfg as:
set tmo_menu 20
tmo_pickup The minimum amount of time Amanda waits between an on-hook and off-hook event.
Number of tenths of seconds from 1 to 99. The default is 20 (2.0 seconds).
The default appears in install.cfg as:
set tmo_pickup 20
tmo_rna For some PBXs, Amanda assumes that the called party is not going to answer the tele-
phone if there is no answer after a certain length of time. The amount of time she waits
is the product of this setting times the maximum number of rings for a Ring No Answer.
(The maximum number of rings is set per mailbox using the Maximum Rings field.)
This setting is in tenths of seconds and is the estimated length of time it takes for a ring.
The default is 60 (which is an estimated six seconds per ring). The range is 0 to 65535.
The defaults appear in install.cfg as:
set tmo_rna 60
General Options (Continued)
Configuration Option Description