Parts
Use listed part numbers only when ordering replacement
parts. Part number are not used in installation instructions.
1
2
3
8
9
7
4
10
5
6
11
12
13
Item
Description
Part number
1
Ice maker
D7824703
2
Ice maker cover
10519801
3
5
/
8
" long sheet metal screw (to
secure ice maker)
M0211118
4
Stainless steel clip
B5720302
5
Ice maker wire harness clamp
10526701
6
Ice maker wire harness
D7813004
7
Ice maker arm
10884401
8
Button plug
M0311301
9
Oblong plug
A3124301
10
Thermal fuse clip (attached to
ice maker)
10319801
11
Plastic clips (4)
M0104106
12
Ice storage bucket
10476201
13
Compression nut and sleeve
10244904
N/S
Warning level (attached to side
of ice maker)
A3036901
N/S
Diagnostic label (inside ice
maker cover)
10834701
N/S
Installation Instructions
10527033
N/S= Not shown
Introduction
!
Recognize this symbol as a
safety precaution.
Read entire manual before installing kit. All necessary tools
and materials must be available prior to installation. Verify
all listed parts are included in kit. If parts are missing,
contact source from whom kit was purchased.
• Mechanical experience is required to install kit.
• If unable to solve a problem during installation, contact
an authorized Amana technician. Locate a Factory
Service Center or independent authorized technician by
calling 1-800-628-5782 inside U.S.A. and 1-319-622-
5511 outside U.S.A. Service is at owner’s expense.
Safety Instructions
!
WARNING
To avoid electrical shock which can cause severe
personal injury or death, unplug power cord or open
household circuit breaker to refrigerator before installing
kit. After installing kit, reconnect power.
!
Caution
To avoid property damage, observe the following:
• Confirm water pressure to water valve is at least 20
pounds per square inch.
• Start nuts by hand to avoid cross threading. Finish
tightening nuts using a wrench. Do not overtighten.
• Check carefully for water leaks prior to returning
refrigerator to normal location and 24 hours after
connection.
Before Connecting Ice Maker
Important
• Before connecting ice maker, contact a plumber to
connect copper tubing for refrigerator water supply to
household plumbing in compliance with local codes and
ordinances.
Use
1
/
4
" (6 mm) flexible copper tubing. Length of copper
tubing must reach from water supply connection plus an
additional 8' (2.5 m) for service loop behind refrigerator.
Tubing should be soft instead of rigid and ends should be
free of burrs.
Copper tubing route must be above 35°F (2°C) to prevent
water line from freezing.
IC8 Top and Bottom Freezer Refrigerator Ice Maker Kit
Installation and Operating Instructions
