Installation
Instructions
Electric Slide-in Range
Keep instructions for future reference. Be sure manual stays with range.
Read entire instruction before beginning installation.
Read Owaners Manual for safe installation
PREPARE TO
INSTALL RANGE
AND INSTALL
ANTI-TIP
BRACKET
Measure cabinet area and prepare
it according to illustrations in
Minimum Clearances to
Combustible Surfaces and Range
and Cabinet Dimensions section in
this manual.
Remove the packing
materials and locate
the anti-tip bracket,
screws and plastic
anchors.
1
Anti-tip
bracket can
be installed
on either
side of
range.
Anti-tip Bracket Installation
To avoid risk of range tipping, secure
range with a properly installed anti-
tip bracket.
1.
Remove storage drawer.
2.
Unscrew rear leveling legs so
they extend at least ¼ inch to
engage bracket.
3.
Move range to where it will be
installed.
4.
Position anti-tip bracket. With
range in position, reach through
storage drawer opening and
slide anti-tip bracket on either
left or right rear leveling leg.
Slide leg into V-shaped notch in
bracket.
5.
Mark location of side and front
of anti-tip bracket on floor.
6.
Remove anti-tip bracket and
range from opening.
7.
Position anti-tip bracket
according to lines marked on
floor, mark 2 hole locations in
anti-tip bracket, remove bracket
and drill 2 holes.
• If drilling into wood, use a
3
/
32
" drill bit. If drilling into
concrete or tile, use a
3
/
16
"
masonry drill bit and insert
plastic anchors.
8.
Secure bracket to floor using
screws supplied.
You'll Need a Few
Things Before You Begin
Important–
Save for local electrical inspector’s use.
Wrench
Screw
Drivers
Level
Power Cord
(3-wire or 4-wire)
and Strain Relief
Tape Measure
Drill and DrillBit
3
/
32
" for wood floor
3
/
16
" for concrete floor
3
/
8
" Nut Driver
or Sockets
