14
Door Gaskets
1.
Clean door gaskets every 3 months according to
General Cleaning instructions. Clean any spills
immediately.
Condenser Coil
Clean condenser coil behind toe grille every 3 months to
ensure maximum performance of refrigerator.
Accumulated dust and lint may cause the following:
• reduced cooling performance
• increased energy usage
• premature part failure
1.
Remove toe grille by holding ends and pulling away
from refrigerator.
2.
Clean front surface of condenser coil with a vacuum
cleaner hose nozzle.
3.
Replace toe grille by inserting clips in holes and
snapping in. See
Leveling Refrigerator section.
4.
Raise stabilizing legs (some models) by turning
counterclockwise.
CAUTION
!
Protect soft vinyl or other flooring with cardboard, rugs
or other protective material to avoid property damage.
5.
Pull refrigerator away from wall. Run a vacuum
brush across grille on back of refrigerator.
Glass Shelves
CAUTION
!
Handle tempered glass shelves carefully to avoid
personal injury or property damage. Shelves may
break suddenly if nicked, scratched, or exposed to
sudden temperature change.
Remove shelf by lifting front, releasing hooks from metal
track then pulling out. Place shelf on a towel. Allow shelf
to adjust to room temperature before cleaning.
Clean crevices by completing the following:
1.
Dilute mild detergent and brush solution into crevices
using a plastic bristle brush. Let sit for 5 minutes.
2.
Spray warm water into crevices using faucet spray
attachment.
3.
Dry shelf thoroughly and replace shelf by inserting
hooks into metal track and lowering it from the front.
Odor Removal
1.
Remove all food and disconnect power to refrigerator.
2.
Clean all interior surfaces including ceiling, floor, and
walls according to General Cleaning instructions
above. Pay special attention to corners, crevices, and
grooves. Include all drawers, shelves, and gaskets.
3.
Connect power to refrigerator and return food to
refrigerator. Wash and dry all containers. Wrap foods
in tightly sealed containers to prevent further odor.
Care and Cleaning
WARNING
!
Disconnect power to refrigerator before cleaning to
avoid electrical shock which can cause severe
personal injury or death. After cleaning, restore power.
CAUTION
!
Read and follow all manufacturer’s cleaning directions
to avoid personal injury or property damage.
General
See section on Stainless Steel Cleaning if doors are
stainless steel.
1.
Wash surfaces with 4 tablespoons baking soda
dissolved in 1 quart warm water and a soft, clean
cloth.
2.
Rinse surfaces with warm water. Dry surfaces with a
soft, clean cloth.
• Do not use the following items:
- abrasive or harsh cleaners, ammonia,
chlorine bleach, etc.
- concentrated detergents or solvents
- metal scouring pads
These items can scratch, crack and discolor
surfaces.
• Do not place buckets, shelves, etc. in dishwasher.
Stainless Steel Cleaning
Damage to stainless steel finish due to improper use
of cleaning products, or using non-recommended
cleaining products, is not covered under warranty.
For Amana recommended products, call our Consumer
Affairs division at 1(800) 843-0304, or contact us on the
internet at www.amana.com.
1.
Wash surfaces with warm soapy water and a soft,
clean cloth or sponge.
2.
Rinse surfaces with warm water. Dry surfaces with a
soft, clean cloth.
• Do not use the following harsh cleaners:
- abrasive or acidic cleaners(ammonia, chlorine
bleach, vinegar-based product, etc.
- citrus-based cleaners
- scouring pads(metal, textured plastic, etc.)
These items can scratch, discolor, or permanently
tarnish surfaces.
3.
Follow up rinsing by immediately drying with a soft,
clean cloth. This will avoid water spotting on
stainless steel finish.
Adhesives
1.
Remove adhesive residue from refrigerator surfaces
by rubbing toothpaste into adhesive with fingers until
adhesive loosens.
2.
Rinse surface with warm water. Dry surface with a
soft, clean cloth.