Страница 1: ... 18 AMANA TOP LOAD WASHER HUB AND SEAL KIT 495P3 ...
Страница 2: ...re 1 using No 237P4 Hex Wrench 5 Remove the spline insert from the transmission tube and discard the old spline insert IMPORTANT Use a new spline insert each time the hex nut is removed DO NOT reuse the old insert as the hex nut may loosen during operation 6 Remove hub from splines on transmission tube NOTE It may be necessary to use a gear puller to remove hub 7 Remove the old water seal from the...
Страница 3: ... as it will cause a water leak 13 Lubricate the inner splines of the new hub assembly supplied in kit with No 27604P Anti Seize compound 14 Carefully place the new hub assembly on the splined transmission tube IMPORTANT Firmly push hub down against the outer tub seal and hold in this position 15 While holdirig the hub down place the spline insert onto the transmission tube until it bottoms against...
Страница 4: ...ap to aid assembly Cover must be placed on outer tub so notch on top edge of outer tub cover is directly over left front clip holes in tub Figure 4 Starting with this hole place each spring clip in its respective hole and snap into place refer to Figure 4 for proper clip installation 19 Reinstall filler hose onto the backfiow preventer NOTE When reinstalling the filler hose the white line on the h...