duII
the remote input can be used to switch between the display brightness level set by the
brgt
function and
the dimmed display brightness set by the
duII
function. The display dull level is selectable from
0
to
63
, where
0
= lowest intensity and
63
= highest intensity. This function is useful in reducing glare when the display needs to
be viewed in both light and dark ambient light levels.
5.51
Auto display brightness high level
Section:
dISP
Display:
Auto High
Range:
15
to
63
Default Value:
63
Default Access Level
2
Function number
22EA
Automatic brightness high level - seen only when
Auto High
is set to
ON
. The high brightness level sets the
maximum brightness which the automatic brightness control can achieve with 64 being the highest intensity.
5.52
Auto display brightness low level
Section:
dISP
Display:
Auto Lo
Range:
1
to
63
Default Value:
7
Default Access Level
2
Function number
22Eb
Automatic brightness low level - seen only when
Auto High
is set to
OFF
. The low brightness level sets the
minimum brightness which the automatic brightness control can achieve with
64
being the highest intensity and
0
being the lowest intensity.
5.53
Select number of alarms
Section:
AL.CF
Display:
AL Cnt
Range:
0
,
1
,
2
,
3
,
4
,
5
,
6
,
7
,
8
Default Value:
2
Default Access Level
4
Function number
437d
Allows selection of the number of alarms required from 0 (
0
) to 8 (
8
).
5.54
Easy access mode
Section:
ACCES
Display:
EASY LEUL
Range:
NONE
,
1
,
2
,
3
,
4
,
5
,
6
,
CAL
Default Value:
NONE
Default Access Level
S.CAL
Function number
0C00
Allows choice of the access level available when using the easy access method. For example if this function is set
to
3
then functions with levels 1, 2 and 3 can be viewed and changed when access to setup functions is made using
this method. To access setup functions using the easy access method press and hold the
F
button until the message
48 of
LD5TMRMAN-1.1-0