Amadas SPC-4, Руководство пользователя

Страница: 27 / 68

Preparation Hi-Speed Cotton Stalk Puller/Chopper
16 7/1/21 MAN157
Overview
Your Hi-Speed Cotton Stalk Puller/ Chopper
has been carefully prepared prior to being
shipped. Additional preparation is required,
however, before the machine is ready for use.
Some of this preparation is usually performed
by the dealer; the rest will need to be done by
you, the user. Please follow the instructions
in this chapter to inspect your SPC and
prepare it for use.
Information in this chapter is intended to
prepare your SPC for general use. Chapter
4, Adjustments , provides suggestions for
adjusting the machine to meet your specific
farming needs.
Set Row Width
Amadas Hi-Speed Cotton Stalk
Puller/Choppers are delivered from the
factory pre-set. The SPC-4 is set for 36", 38",
or 40" rows; the SPC-6 is set for 36” or 38”
rows. When you order a machine, you
specify the desired row width. If the row
width of machine needs to be changed, refer
to Chapter 4, Adjustments , for specific
instructions. On a new machine, this
procedure takes approximately four man
hours to complete. Allow several additional
man hours for changing the row width on a
used machine.
Different Model Numbers
This manual covers Hi-Speed Cotton Stalk
Puller/Choppers manufactured under model
numbers:
SPC-4
SPC-6
Minor differences exist between the various
models with regard to safety shielding. In
addition, the SPC-6 contains six rows of
blades, rather than four, as on the SPC-4
and earlier CSP models. While the SPC-4 is
the model used in most of the pictures and
sketches in this manual, the information and
instructions apply to all models.
If you have a CSP01 or CSP02, please refer
to your parts catalog for information on the
safety shields specific to your model.