Amada ML-7 Series, Руководство по эксплуатации, Страница: 91 / 93

A
Appendix
87
ML-7 Series/ML-9001A
Appendix A Troubleshooting
If no laser beam is projected, follow these steps as a corrective action.
A.4 If No Laser Beam Is Projected
No laser beam is emitted
The required marking parameters and data
are assumed to be set in the controller. *
To correct the problem, follow the
instructions given on the RAS screen.
Release the Emergency Stop switch.
Short pins 4 and 5 of the remote
interlock connector.
NO
YES
NO
NO
Does the computer
or Operating Unit
indicate an error?
Was the Emergency Stop
switch pressed?
Contact your Amada
Miyachi representative.
Is the remote
interlock enabled?
(Applies only if
remote interlock
signals are used.)
YES
YES