Amada ML-2350A-CE, Руководство по эксплуатации, Страница: 161 / 235

4. Commands
161
ML-2350A/2351A
Chapter 5 Laser W
elding by External Communication Control (RS-485 CONTROL)
Introduction Part
Operating Part
Maintenance Part
Appendixes
Installation
and
Preparation
Part
Set Value/Monitor Value Table
⇒
The items marked * are monitor values. These values can be read out but
cannot be set.
⇒ The value in ( ) indicates the unit.
⇒
The unit of time setting depends on the setting of "7" of SWITCH 1 on the
MEMORY SWITCH screen. When setting to ON, set the values in increment of 5.
99 Settings for the Cooler (Set the schedule No. [SH1/SH0] to 00.)
Data No. Item Data Range
01* Coolant temperature 000 – 999 (×1°C)
02
[REF TEMP] on the [INITIALIZE] screen
Control temperature
00 – 99 (×1°C)
03
[HIGH] of ALARM on the [INITIALIZE] screen
Coolant temperature high alarm
00 – 99 (×1°C)
04
[LOW] of ALARM on the [INITIALIZE] screen
Coolant temperature low alarm
00 – 99 (×1°C)
05* Coolant resistivity 000 – 999 (×0.01MΩ)
84 Schedule Settings for both FIX and FLEX
Data No. Item Data Range
01
[FORM] on the [SCHEDULE] screen
Selection of waveform setting method
0: FIX 1:FLEX
0 – 1
02
Set waveform display on the [SCHEDULE]
screen
0: OFF 1:ON
0 – 1
03
[PEAK POWER] on the [SCHEDULE] screen
Laser output peak value
ML-2350A: 0000 – 0700 (×0.01kW)
ML-2351A: 0000 – 0500 (×0.01kW)
04
[REPEAT] on the [SCHEDULE] screen
Pulse repetition rate
000 – 200
05
[SHOT] on the [SCHEDULE] screen
Number of consecutive shots
0000 – 9999
06
[HIGH] on the [MONITOR] screen
Energy monitor upper limit setting
0000 – 9999 (×0.1J)
07
[LOW] on the [MONITOR] screen
Energy monitor lower limit setting
0000 – 9999 (×0.1J)
08
Power monitor waveform display on the
[MONITOR] screen
0: OFF 1:ON
0 – 1
09
[REFERENCE SETTING] on the [MONITOR]
screen
Lamp input power upper limit setting
000 – 100 (×1%)
85 Schedule Settings for FIX
Data No. Item Data Range
01 [

SLOPE] TIME on the [SCHEDULE] screen 000 – 300 (×0.1ms/x0.01ms)