Amada ML-2350A-CE, Руководство по эксплуатации, Страница: 155 / 235

3. Initial Settings
155
ML-2350A/2351A
Chapter 5 Laser W
elding by External Communication Control (RS-485 CONTROL)
Introduction Part
Operating Part
Maintenance Part
Appendixes
Installation
and
Preparation
Part
2
Specifying Communication Schedules
(1) Set communication schedules by setting 1 to 6 of "SWITCH 2" to ON or OFF.
Move the cursor to the switch to be changed and press the ON key or OFF key
for this setting.
1: Data bit length (OFF: 8 bits, ON: 7 bits)
2: Parity bit (OFF: Parity bit, ON: No parity bit)
3: Parity mode (OFF: Even, ON: Odd)
4: Stop bit (OFF: 2, ON: 1)
5/6: Communication speed (as shown in the following table depending on the
combination of ON and OFF)
SW2-5 SW2-6 bps
OFF OFF 9600
OFF ON 19200
ON OFF 38400
ON ON (9600)
7/8: Unused
In this example, each item is set as shown below.
Switch No. Setting Setting example
1 (Data bit) ON 7bit
2 (Parity bit) ON None
3 (Parity mode) OFF Even
4 (Stop bit) ON 1bit
5/6 (Communication speed) 5: ON 6: OFF 38400bps
(2) Press the "BACK" button.
Returns to the INITIALIZE screen.
<Note>
When any SWITCH 2 setting has been changed, turn OFF the power supply before
a laser output, and then turn it ON again.
Setting Equipment No.
Display the INITIALIZE screen on the laser controller of the laser and set
equipment No. (NETWORK #).
⇒ For controlling multiple lasers by single personal computer, it is necessary to
register equipment No. (NETWORK #) for each equipment. Set equipment No.
without duplication. If duplication of equipment No. exists, a data collision will
occur on the communication line and the laser cannot be correctly operated.