Amada ML-2350A-CE, Руководство по эксплуатации, Страница: 119 / 235

1. Operation Flow
119
ML-2350A/2351A
Chapter 3 Laser W
elding by Laser Controller (P
ANEL
CONTROL)
Introduction Part
Installation
and
Preparation
Part
Operating Part
Maintenance Part
Appendixes
Chapter 3
●
Laser Welding by Laser Controller
(PANEL CONTROL)
1. Operation Flow
This section explains a laser welding operation flow by laser controller.
The following methods for laser welding operations are available: control from the
laser controller (PANEL CONTROL), control by external input/output signals from
the connected PLC (Programmable Logic Controller) (EXTERNAL CONTROL), and
control by sending a command from the connected personal computer (RS-485
CONTROL).
At PANEL CONTROL, welding schedules are set by using the laser controller and
laser light is output.
Operating Part
MAIN POWER switch ON
CONTROL keyswitch ON
READY
Screen
SCHEDULE
Screen
Setting and registration of SCHEDULE
number (output schedule number) and output
schedules
Control method check (PANEL CONTROL)
SHUTTER: ON (branch shutter selection)
POSITION: ON (guide light output)
SCHEDULE number input
SCHEDULE Screen
or
MONITOR Screen
Laser light output
CONTROL keyswitch OFF
MAIN POWER switch OFF
MONITOR
Screen
Laser energy/average power check
STATUS
Screen
HV: OFF (High voltage OFF)
SCHEDULE
Screen
STATUS
Screen
MONITOR
Screen
SEAM
Screen
Pressing the LASER START/STOP button