Amada MF-C300A-SF, Оригинальное руководство пользователя, Страница: 91 / 199

4 . Setting the Laser Light Output Schedule
91
MF-C300A-SF/C500A-SF
Chapter 2 V
arious Settings
Introduction Part
Inst
allat
ion and Preparation Part
Operating Part
Maintenance Part
Appendixes
Setting the Output Schedules for Seam Processing
The method of setting the output waveform for seam processing by using the
fade-in/out function after displaying the SEAM screen is explained below .
⇒
Only in the FIX or FLEX mode, the waveform for seam processing can be set.
1
Setting the Output Schedules
Taking seam processing in which laser light is continuously output 100 times, as an
example, the output count of "POINT 01" to "POINT 06" and energy are set. The en-
ergy at the beginning/end of laser light output is made weaker by the fade function.
This prevents an overlapped portion at circumferential seam processing against an
excessive burn and makes the processing mark of the final shot inconspicuous.
⇒
The fade function can also be set for other processes than the beginning/end of
processing.
(1) Press the "SEAM" button to display the SEAM screen.
2
Setting the Fade-in/out Function
(1) Press the "SHOT [count]" setting button of "POINT 01."
Enter the laser light output count by using the numeric keypad and then press the
ENT key. Set 0001 because of the first output count.
⇒
For "SHOT [count]" of "POINT 01", only 1 can be set.
(2) Press the "POWER [%]" setting button of "POINT 01."
Enter the laser output value (%) by using the numeric keypad and then press the
ENT key.
Set the ratio to "SET POWER" set on the SCHEDULE screen in the range of 0 to
150.0%.
(3) Likewise, set "SHOT [count]" and "POWER [%]" of "POINT 02" to "POINT 06."
⇒ For "POINT 06", press the button to scroll the POINT display column to the
right. Then, it is displayed.