Amada MF-C2000A Series, Руководство по эксплуатации, Страница: 167 / 272

4 . Programming
167
MF-C2000A Series
Chapter 4 Laser Processing by External Input/ Output Signals (EXTERNAL
CONTROL)
Introduction Part
Operating Part
Maintenance Part
Appendixes
Installation
and
Preparation
Part
4 . Programming
This section explains the precautions for programming laser processing by ex-
ternal input/output signals (EXTERNAL CONTROL) .
The timing chart of the appendix shows the input signal length and input waiting time
required to correctly operate the laser. Perform actual programming referring to this
timing chart.
In the following, a control flow is explained by taking the case where "Schedule 1" is
first specified and then "Schedule 2" is specified to perform a single laser light output
from the branch 1, as an example.
1
Switching the Control Method
(1) Put pin No.25 (control switching) of the EXT. I/O (1) connector in a closed circuit.
Pin No.23 of the EXT. I/O (1) connector is put in a closed circuit and the signal
(external input acceptable) is returned from the laser.
⇒
Press the STATUS button on the laser controller to display the STATUS screen.
Then, you can confirm that "EXTERNAL CONTROL" is selected as the control
method.
2
Turning ON the LD Power Supply
(1) Put pin No.4 of the EXT. I/O (1) connector in a closed circuit to turn ON the LD
power supply.
Pin No.11 of the EXT. I/O (1) connector is put in a closed circuit after 5 seconds
maximum and the signal (LD ON) is returned from the laser.
3
Setting Output Schedules (SCH .#01)
(1) Set the SCHEDULE number by combining pin No.27 to pin No.34 of the EXT. I/O
(2) connector. In this example, pin No.27 of the EXT. I/O (2) connector is put in a
closed circuit for 16 ms or more to set SCH.#01.
⇒
At delivery, the signal acceptance time (time from a signal input till establishment
of schedules) of processing schedules is set to 16 ms. Set the close circuit time
referring to this value. As the signal acceptance time, 0.1 ms, 1 ms, 2 ms, 4 ms,
ON
OFF
ON
OFF
ON
OFF
Control switching
input
LD ON output
LD-ON
OFF input
External input
acceptable output
5s max.
ON
OFF
ON
OFF
ON
OFF
Control switching
input
LD ON output
LD-ON
OFF input
External input
acceptable output
5s max.
↓